Sailing yachts

Percy See bermudan cutter

(REF: 18021)


  • Designer: See, Percy M
  • Builder: Percy M See
  • Year: 1956
  • Location: Greece
  • Length on deck: 37'
  • Beam: 9'
  • Draft: 6'

Enquire about Percy See bermudan cutter

Please fill in this form and we will contact you about this boat

Apply for finance

Visit our partner’s website to apply for finance

Apply now

Full specification

Wooden ships comments on this Percy See Bermudan cutter

Designer:   Percy See,  Fareham, Hampshire.


Builder:     Percy See


Year:          1956

Construction:    Carvel mahogany planking all copper fastened to steam bent oak frames.  Elm stem, stern post and backbone.

Iron ballast keel with iron keel bolts, galvanised strap floors, removed, regalvanised and replaced with new bronze bolts.

Tiller steering to heavy elm rudder on stainless steel rudder hangings.

Yacht laid teak deck over a ply subdeck, new in 2012.  Varnished teak king plank, coverboards and margin board.

Varnished mahogany coachroof and cockpit coamings with teak toe rails and hatches and bronze portholes.

 Percy See bermudan cutter


Masthead Bermudan sloop rig on a Sparlight alloy mast with twin spreaders, standing backstay and Furlex roller furling forestay

Standing rigging all new 2007/2009.  New synthetic running rigging.



30hp 3cyl Volvo Penta fitted new in 2011.  Conventional gearbox with single lever control and stainless steel shaft to 3 blade bronze folding propeller.

Stainless tank with filter and water separator



Steps down over the engine box with large quarter berth to starboard.  Galley to port with 2 burner gas oven an grill an single stainless steel sink.

Chart desk to starboard forward of the quarter berth with electronic navigation equipment and storage.

Keyhole bulkhead with port and starboard settee berths.  Ample storage above and below.

Heads compartment on starboard side with Jabsco sea toilet.  Hanging locker to port.

Large double berth in the forepeak.



Foruno GP31 GPS


Clipper AIS receiver

PC Navtex receiver

Raymarine X5 tiller pilot

4 solar panels

15kg Bruce anchor with 10mm chain

Additional 15mm warp


Manual bilge pump

12v electric bilge pump

Fire extinguisher

Fire blanket

Carbon monoxide alarm

4 man liferaft

Tender with Honda outboard 2012

This yacht had a major refit finishing in 2012 when she was sold to the present owners.  They have since cruised extensively, ending up in Greece where the boat is now lying.

She is an exceptionally smart boat and has been well cared for, benefitting from two extensive periods of refit in the last 20 years.


These particulars have been prepared in good faith from information provided by the Vendors and are intended as a guide, Wooden Ships cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. The Purchaser should instruct his agent or surveyor to validate all details as necessary and satisfy himself with the condition of the vessel and its equipment.