Wooden Ships Comments on this Salcombe River Launch
Clinker motor launch built in Salcombe in the 1990’s by Fred Bennet.
She has been stored ashore under cover for several years and now needs a light refit before going back afloat. Hull appears to be in very good condition, worked required is mainly cosmetic.
A very pretty and relatively recent launch, perfect for family trips on the river. Comes with a trailer.
Clinker planked in a type of pine, copper rivet fastened to steam bent oak timbers
Oak stem, keel and transom.
Mahogany gunnells with a rope fender all round.
Small aft and fore decks in laid iroko over a marine plywood subdeck. Bulkheads of marine plywood.
Bronze fairleads and cleats on both decks.
Varnished mahogany thwarts.
Transom hung mahogany rudder with bronze hangings.
Stuart Turner single cylinder 1.5hp marine petrol engine installed new.
Engine condition unknown as it has not been run for a while.
Bronze shaft to a 3 blade bronze propeller.
Fuel tank under the foredeck.
Full specification and details available upon request
These particulars have been prepared in good faith from information provided by the Vendors and are intended as a guide, Wooden Ships cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. The Purchaser should instruct his agent or surveyor to validate all details as necessary and satisfy himself with the condition of the vessel and its equipment.